When part of the soil under a concrete slab shrinks or settles, that part of the house drops and the rest doesn't. Slab repair puts supports under the low area so it stops moving and, where possible, lifts it back toward level. Call (956) 948-6969 to be connected with an independent local contractor who repairs slab foundations in Brownsville.
How it usually works
Most slab repairs in the Valley use piers: columns of concrete or steel installed under the edge of the slab, and sometimes under the interior, down to soil that moves less than the surface clay.
- Pressed concrete piers are short concrete cylinders stacked and pushed into the ground with a hydraulic jack until they won't go further.
- Steel piers are steel pipes driven deeper, often to a measured load.
- Drilled concrete piers are holes drilled and filled with reinforced concrete.
Each has trade-offs in depth, cost and how it handles very wet or very dry clay. A good contractor will explain why they're recommending one type for your house, not just name a product.
What a solid proposal includes
Before you sign, the written estimate should spell out:
- How many piers, and where. Ideally on a sketch of your house.
- The pier type and target depth. Or the load they'll be driven to.
- Before and after floor elevations. You want numbers, not just "we'll level it."
- What happens with plumbing. Lifting a slab can stress drain lines. Ask whether they recommend a plumbing test before or after the work.
- Who pulls the permit. Many cities require one for structural repairs. Brownsville homeowners should check with the city's building department or ask the contractor to confirm.
- The warranty. How long it lasts, what it covers, and whether it transfers if you sell the house. A transferable warranty can matter to a future buyer.
- Cleanup and landscaping. Exterior piers mean digging next to the house.
Repair is not always the answer
If movement is small and not getting worse, a contractor may suggest monitoring it, or fixing drainage or a plumbing leak first. Brownsville's clays react strongly to water, so sometimes the cause is a downspout dumping next to the slab or a leak under it. Be wary of anyone who pushes a full pier job without measuring first.